Assembly and operating instructions
AEROMAT 80
7
08.2021
Operation
You can shift the operating lever manually. We recommend to use the rod operating device for SIEGENIAat an installation
height of 1.80 m and higher (see chapter "Rod operating device" and "Accessories"). Do not use any inappropriate auxiliary
materials to operate the unit.
Airflow setting
1. Open the fan flap
2. Close the fan flap
1.
2.
Maintenance
If you notice that the ventilator does not close properly or is difficult to open because the compression strength of the fan flap
is not correct, you can adjust the compression strength by means of a small screw on the front panel of the unit.
• Slightly turn the screw into the desired direction using an appropriate screwdriver.
(+ = increase the compression strength; - = decrease the compression strength)
-
+
Besides cleaning it, the AEROMAT 80 does not need any further maintenance. If any malfunctions arise, please contact
SIEGENIA.
Cleaning
Caution!
›
Only clean the AEROMAT 80 as to where the unit is accessible safely. Observe the safety regulations for ladders, steps,
works in particular heights etc.
›
If required, clean the outer parts of the AEROMAT 80's casing using a suitable cloth, which has been moistened with a
mild soap sud or washing-up liquid.
›
Never use cleaning agents that are aggressive or contain solvents, as these may damage the surface of the unit.
