Siebe Group Company Barber Colman 7SD, Инструкция по эксплуатации

Страница: 12 / 32

12
Configuration Procedure
1) Switch off power to the instrument.
2) Remove the instrument from its case.
3) Open switch V2, located 1 inch behind the upper right
corner of the display (see Figure 1).
V2
Figure 1
4) Re-insert the instrument in its case.
5) Switch on power to the instrument. If “CAL” is
displayed, press the
▲
key to select the configuration
procedure “CnF”.
6) Press the FUNC key.
The 3 digit dual display and 3 digit heat/cool models
show the parameter code on the lower display and
the parameter value on the upper display. The 3 digit
deviation bar model alternately shows the parameter
code and its value on the display.
CONFIGURATION PROCEDURE
Configuration Key Functions
FUNC = The new setting of the selected parameter is
stored and the display advances to the next
parameter.
AT = Scrolls back through the parameters without
storing the new setting.
▲
= Increases the setting of the selected parameter.
▼
= Decreases the setting of the selected parameter.