For software version (operating terminal) 3.18 and higher, check sum errors are dis-
played. If a check sum error is detected in the header of the parameter set while read-
ing it from the operating terminal, the following error message will appear:
Software version (operating terminal) 3.19 and higher compares the features of the
saved parameters with the features of the drive. The parameters will be loaded into the
drive only if the drive supports all features of the related parameters. Otherwise, one of
the following error messages will be displayed.
The hardware does not support all features of the parameter sets:
The logic software does not support all features of the parameter sets:
The firmware does not support all features of the parameter sets:
Note
The messages are displayed for 2 seconds. Afterwards, the display switches back to the
AUTOMATIC MODE.
14.3.7
CLEAR TERMINAL DATA
Note
You must enter the correct password to open this menu item.
If you select the menu item CLEAR TERM DATA, the internal memory of the terminal
will be cleared, i.e. all parameter sets are deleted, the password and the brightness of
the display are reset to the default values.
Afterwards, the display switches back to the PROGRAM MENU.
35
Drive System SD2x - Operating Terminal 0362150 and 0362153
Functions of the Terminal
