Connection to the Drive
8
Connection to the Drive
The female connector X62 of the operating terminal 0362150 or 0362153 is connected
to the COM1 interface of the drive. The designation of the COM1 interface varies de-
pending on the device:
Drive
Device designation
COM1 interface
SD2S
036212xxx / 0362x4xxx
X19
SD2M
036228xxF
X19
SD2M
0369x7xxF
X74
SD2B
0362170xx
X10
SD2B plus
0362171xx / 0362171xx1
X10
Operating terminal 0362150
The female connector X62 (COM1) of the operating terminal is directly plugged on the
male COM1 connector of the drive. Then, the operating terminal is fixed by a screw. Af-
ter fixing, the connection to the drive is established. The supply voltage for the terminal
is also supplied via this connection.
Note
When using the operating terminal with a drive of the series SD2B / SD2B plus or SD2M
(0369x7xxF only), the terminal cannot be direclty plugged on the drive for mechanical
reasons. With these devices, you can connect the operating terminal via a cable to the
COM1 interface of the drive.
Note
As an alternative, the operating terminal 0362150 can also be connected via the switch
cabinet kit 32299567. For the mounting instructions, refer to the technical information
“TIE_MountingPlate_OperatingTerminal_0362150.pdf”.
Operating terminal 0362153
The female connector X62 (COM1) of the operating terminal 0362153 is connect-
ed to the male COM1 connector of the drive by means of an extension cable. For
the mounting instructions and a mounting template, refer to the technical information
“TIE_OperatingTerminal_0362153_Mounting.pdf”.
16
Drive System SD2x - Operating Terminal 0362150 and 0362153
