4.3
Assembly
DANGER
Bypassing the protective device
Hazard due to lack of effectiveness of the protective device
b
Prevent any incentives to tamper with the safety locking device; for example, with
the following measures:
Variant for universally coded actuators only:
°
Cover the safety switch and the actuator with additional equipment or protect
them against access.
Actuation direction
The safety locking device can be actuated from all 4 horizontal directions. The lock only
locks in the actuation direction, i.e., to the side.
4
2
1
3
Figure 2: Possible actuation directions
From front
From left
From rear
From right
The safety locking device is
not
suitable for vertical actuation. The lock does
not
pre‐
vent the actuator being moved upward out of the response range.
Figure 3: No vertical lock
Distance
If multiple safety locking devices are mounted on the machine, they must be mounted
at least 120 mm apart.
4
PROJECT PLANNING
12
O P E R A T I N G I N S T R U C T I O N S | TR10 Lock
8019972/2016-07-19 | SICK
Subject to change without notice
