SICK RFU61 Series, Руководство по эксплуатации

Страница: 38 / 54

8 Operation
8.1 Operating options
The device is configured for operative use in a system using the configuration tools of
the PLC and the type-specific IODD file. Using requests, the sequence program of the
PLC controls access to the fieldbus and the IO-Link master on the device for reading
and writing the UHF transponder.
To demonstrate its operating principle, the device can also be set up with the SOPAS ET
configuration software.
NOTE
In addition to these operating instructions, we recommend using the type-specific
document “Technical Information IODD”:
•
For the parameterization and process data, the document lists the available
parameters and functions of the device.
•
This document assists the user when setting up the device for demonstration of
operative use.
The type-specific IODD Technical Information can be found on the product page in the
Internet at:
www.sick.com/RFU61x
8.2 Status indicators
8.2.1 Optical status indicators on the display panel
m
ic
ro
S
D
R
F
R
e
a
d
y
IO
-L
in
k
Table 9: RFU610-107xx: Function of the status displays
Display LED Color Status
Ready OFF – Device without supply voltage
Flashing
1)
Orange The device is not ready for use:
The internal temperature of the device is below -25 °C.
Flashing
1)
Green Warm-up phase of the device:
The internal temperature of the device is between -25 °C
and -20 °C. The device starts regular operation after
approx. 1 min.
Lights up Green The device is ready for use.
Lights up Red The device is not ready for use: hardware fault
RF Lights up Green The UHF field is switched on.
Lights up Red Interference: Integrated antenna or RF part
IO-Link Lights up Green Communications between master and device via IO-Link
exists
8
OPERATION
38 O P E R A T I N G I N S T R U C T I O N S | RFU61x IO-Link 8026854//2021-09-01 | SICK
Subject to change without notice