SICK Omni CLX490 Series, Руководство по эксплуатации

Страница: 72 / 158

Chapter 6 Operating Instructions
CLX490 Compact OMNI Scanner
6-14
©
SICK AG · Division Auto Ident · Germany · All rights reserved 8009237/RB47/2007-08-03
Operation
6.5 Operating modes and outputing the reading result
The following CLX operating modes/functions can be selected in CLV-Setup:
Standard operating mode:
•
Reading mode
For setup:
•
Percentage evaluation
For adapting the device to the application at hand:
•
Configuring (parameterizing ) the CLX
See Chapter 6.4.1 Configuring the CLX with CLV-Setup, Page 6-4
•
Background teach-in
•
Background analysis
For monitoring purposes/troubleshooting:
•
Display and edit operating data
•
Reading diagnosis
•
Monitor host interface
•
Auxiliary input
•
Self-test
6.5.1 Reading mode (standard operating mode)
The CLX performs a self-test after it has been switched on. It switches to Reading mode
("Device Ready" LED lights up). In the default setting the "Sensor" switching input is the (ex-
ternal) trigger source of the reading pulse. The reading result is output by the CLX at the end
of the reading pulse via the host interface (default setting) and auxiliary interface.
Depending of the configuration, the "Result 1" to "Result 4" switching outputs become live
for the predefined pulse length when defined events occur during the reading process (e. g.
Good Read).
The reading result of the auxiliary interface can be displayed in the CLV-Setup Terminal
Emulator. The CLX auxiliary interface must be set to the R
EADING
D
IAGNOSIS
mode for this pur-
pose. This mode is selected for the default setting. The reading result of the auxiliary inter-
face has a fixed, invariable format.
The Reading mode can be called up by choosing V
IEW
in the menu bar or via the Terminal
Emulator.
Displaying the reading result in the Terminal Emulator:
1. Click in the toolbar.
The Terminal Emulator window is then displayed.
2. In the D
EVICE MODE
section, choose R
EADING
M
ODE
.
3. Present the bar code pattern from Fig. 6-1 to the CLX and activate the reading pulse.
The scan line must not hit any object in a distance closer to the CLX than the rep-
resented bar code (default setting: autofocus mode "Minimum distance").
The "Sensor" LED lights up and the red scan line appears. Also refer to Chapter 6.3.1
Switching the CLX on for the first time with the factory default settings, Page 6-3 .