1.
Position the first object.
2.
Enter the reference value for the first object in
Target value 1
.
3.
Click on the
Teach-in point 1
button.
4.
Position the second object.
5.
Enter the reference value for the second object in
Target value 2
.
6.
Click on the
Teach-in point 2
button.
✓
The sensor calculates the suitable shift and span values and applies these to the
measurement.
Teaching-in for thickness measurement
1.
Position object with a known reference thickness in front of the sensor.
2.
Enter the reference thickness in the
Reference thickness
field.
3.
Click on the
Teach-in
button.
✓
The sensor calculates the suitable span value and applies this to the measure‐
ment.
NOTE
The span and shift values can be adjusted manually at any time after the teach-in.
7.3.7.6
Setting One shot
If this function is activated, the output is only given once when the conditions for output
are met. The output is then switched off.
The output time is set via Off Delay.
OPERATION
7
8021391//2017-10-06 | SICK
O P E R A T I N G I N S T R U C T I O N S | OD5000
45
Subject to change without notice
