7.3.6.2
Setting the Hold function
The Hold function extracts a specific value such as the maximum or minimum value
within a detection period. The value which was set under
Hold Set
is used as the holding
period.
•
Use this function after entering Hold Reset if Auto Peak or Auto Bottom is used.
Off
When the hold function is deactivated, the measurement result is output in an unedited
format and the Hold Input is ignored.
ON
OFF
1
2
Figure 37: Hold function off
1
Measured value
2
Hold function
Peak
The highest value within the detection period is output.
ON
OFF
1
2
3
4
5
Figure 38: Hold function peak
1
Measured value
2
Hold
3
Detection period
4
Internal measured value
5
Measured value for the hold function peak
Bottom
The lowest value within the detection period is output.
7
OPERATION
38
O P E R A T I N G I N S T R U C T I O N S | OD5000
8021391//2017-10-06 | SICK
Subject to change without notice
