2
Safety information
2.1
Intended use
The 3D LiDAR sensor MRS6000 reliably detects its surroundings over 24 layers using a
high density of scan points and an aperture angle of 120°. Its special mirror technology
also ensures a high level of scan stability. Using the multi-echo technology, the LiDAR
sensor scans through rain, dust and fog, while simultaneously multiplying the point
density. These properties as especially suitable for complete creation of a 3D point
cloud that can be used to solve many complex applications.
Typical application areas are, for example, anti-collision monitoring and rear area moni‐
toring in industrial (autonomous) vehicles, person counts in passenger locks, monitor‐
ing of land and buildings, volume monitoring, automated guided vehicle systems for
outdoors, robot area, traffic and park management systems.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.2
Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Device should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
2.3
Internet protocol (IP) technology
NOTE
SICK uses standard IP technology in its products. The emphasis is placed on availability
of products and services.
SICK always assumes the following prerequisites:
•
The customer ensures the integrity and confidentiality of the data and rights
affected by its own use of the aforementioned products.
•
In all cases, the customer implements the appropriate security measures, such
as
network separation, firewalls, virus protection, and patch management.
2.4
Limitation of liability
Relevant standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when com‐
piling the data and information contained in these operating instructions. The manufac‐
turer accepts no liability for damage caused by:
SAFETY INFORMATION
2
8022069/114M/2019-07-17 | SICK
O P E R A T I N G I N S T R U C T I O N S | MRS6000
7
Subject to change without notice
