SICK MARSIC200, Техническая информация

Страница: 36 / 68

3 Initial start-up
3.1 Initial start-up
NOTE
Prerequisite: The system has been fully installed and connected
1. Check installation is correct.
2. Instrument air must be available on the sample conditioning and zero gas on the
distribution unit.
3. Remove the red protective foil from the control unit on the analyzer.
4. Switch on all fuses in the distribution unit.
✓
The LEDs on the control unit are on, the measured values blink.
5. Set the Stand-by switch on the distribution unit to OFF (normal operation).
6. Set the number of available measuring points.
°
Four measuring points are activated upon delivery
Set the available number of measuring points:
b
Login as “Service” on the operator panel in menu Login.
b
Call up menu Parameter/Special fct./Meas.point autom./Meas.point
(MPi).
Back Enter
See logbook
1 1
2 2
3 3
4 4
Meas.point (MPi) .5.10.1.1
./Parameter/Special fct.
On
On
On
On
b
Activate each measuring point desired (set to “On”).
7. Set the date and time in menu Parameter/Date-Time.
8. Wait until the system has warmed up (approx. 2 hours).
9. The system performs an automatic zero point adjustment.
10. The green LED goes on, the measured values do not blink and MEASURE is shown
on the screen
11. Check the flow rate on the flowmeter (in the distribution unit): Approx. 60 l/h. Set
on the flowmeter when necessary.
12. Check that only the green LED lights on the control unit.
°
When the yellow or red LED is on: Press the “ DIAG ” button and/or check in
the logbook.
13. Check the time. Set the time, if required: Menu: Parameter/Date-Time.
14. Configure the test gas concentration in the respective menu on the control unit:
See “Operating Instructions MARSIC200”.
15. Perform manual test gas adjustment: See “Operating Instructions MARSIC200”.
16. Check measured values for plausibility.
17. Perform the leak tightness check: See “Operating Instructions MARSIC200”.
✓
The system is in operation.
3
INITIAL START-UP
36 T E C H N I C A L I N F O R M A T I O N | MARSIC200 8017324/15A2/V6-0/2019-10 | SICK
Subject to change without notice