SICK LCUR1-411, Руководство по эксплуатации

Страница: 26 / 76

Chapter 5 Operating instructions
LCUR1­411
26
© SICK AG • Industrial Safety Systems • Germany • All rights reserved 8011281/TF99/2013-02-28
Electrical installation

Under constant pressure and with simultaneous

Gentle pivoting movement away from the terminal, guide screwdriver to the stop,

Insert stripped wire,

Remove screwdriver, the contact is then made.
5.1.2 Configuration of the LCUR1­411 to suit the old device to be replaced
Depending on the ESPE to be replaced, wire links need to be fitted to the LCUR1­411 to
achieve the correct function. The setting for the wire jumpers is described in the following
tables.
The setting as supplied is wired for LVU206-1406 on terminal 1.2 and 3.2.
Selection 2: terminal assignment on the logic
module
Do not
change
Check and wire to suit the old
device to be replaced
a b c d c‘ d‘
3.4 1.4 3.3 1.3 3.2 1.2
Old device type Selection 1:
wire links
(pink) core colour of the wire links
LVU
200/300
A1,
pk
(G)
G1
gr wh

Not permitted! pk (C) pk (D) 450-1400 G2
206-1406 G3
LVS 300-1600 G4
pk (C) pk (D)

Not permitted!
AGS G5
Colour coding: gr = grey, wh = white, pk (C) = pink with Clip C, pk (D) = pink with Clip D,
pk (G) = pink with Clip G
Selection 1 : Starting from terminal A1 as per the table, lay the pink wire link to a terminal
between G1 and G5 depending on the old device. As supplied the link is connected for
LVU206-1406 from A1 to G3.
Fig.11: Using the spring
terminals
Note
Tab.3: Setting for the wire
jumpers in the LCUR1­411 to
suit the old device to be
replaced