SICK FLOWSIC200, Руководство по эксплуатации

Страница: 79 / 122

Commissioning and parameterization
FLOWSIC200 · Operating Instructions · 8013271/1CJ9/V2-0/2022-01 · © SICK Engineering GmbH 79
4.2.11
Data backup
All parameters relevant for recording, processing and input/output of measured values as
well as current measured values can be saved and printed. This allows easy reentering of
set device parameters as needed (e.g. after a firmware update) as well as the registration
of device data or device states for diagnostic purposes.
The following options are available.

Saving as a project (particularly advantageous for diagnosis and troubleshooting)

Not only device parameters but also data logs can be saved.

Saving as a device file

Saved parameters can be processed without a device connected and transferred to the
device again later.

Saving as a protocol
Device data and parameters are registered in the Parameter protocol.
A Diagnosis protocol can be created for analysis of the device function and recognition
of possible malfunctions.
Saving as a project
It is recommended to save frequent connections as a “Project”. It is then only necessary to
open this “Project” when reconnecting to the device. All data saved beforehand are then
transferred automatically to SOPAS ET.
To save the project, select the respective device, call up menu “Project / Save project as”
and specify the target directory and file name. The name of the file to be stored can be
chosen freely. It is useful to specify a name with a reference to the measuring point
involved (name of the company, equipment name).
Fig. 66 Menu “Project / Save project“
See the Service Manual for a description.