SICK FLOWSIC100 Flare-XT, Руководство по эксплуатации

Страница: 50 / 188

50 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V1-0/2020-10 · © SICK Engineering GmbH
Installation FLSE100-XT
5.6.6.1
Nozzles, blind flanges and seals
Nozzles are delivered with factory adaption to the nominal pipe diameter, welding bevel and
marking for nozzle alignment according to the gas flow.
Fig. 20 Nozzle
Nozzles and blind flanges
Table 4 Available nozzles and blind flanges
Seals
Flat seals are required for the flange connection between nozzle and ball valve and
between the ball valve and the sender/receiver unit. These seals are included in the
standard scope of delivery of the ball valve and/or sender/receiver unit.
Table 5 Available seals
2
1
1 Welding bevel
2 Marking
NOTICE:
Observe the diagrams on

p. 165, §12.7 .
Flange connection Material Temperature ranges
CL150
LTCS P355 QH1 / A350 LF2 -46 … +280°C
SS 1.4401, 1.4404, ASTM A182 Gr. 316, 316L
-196 … +280°C
CL300
LTCS P355 QH1 / A350 LF2 -46 … +280°C
SS 1.4401, 1.4404, ASTM A182 Gr. 316, 316L -196 … +280°C
PN25 DN50
LTCS P355 QH1 / A350 LF2 -46 … +280°C
SS 1.4401, 1.4404, ASTM A182 Gr. 316, 316L
-196 … +280°C
NOTICE:
Observe the diagrams on

p. 165, §12.7 .
Dimension drawings of the nozzles are available on the product CD and/or
available from SICK.
To prevent galvanic corrosion between LTCS nozzles and stainless steel ball
valves, a nozzle insulation set (sealing material set with polymer seals and
sleeves) is available as an accessory,

p. 62, §5.6.8 .
NOTICE:
Observe the diagrams on

p. 165, §12.7 .
Material Temperature range
Serrated gasket B9A 1.4571 -196 … +280°C