38
8015675/1EEU/2021-12| SICK
OP E R A T I N G I N S T R U C T I O N S | Flow-X
Subject to change without notice
6
TROUBLESHOOTING
6
Go to the “Flow rates” menu of the Flow-X flow computer.
7
Check the value for “Gross volume flow rate” matches the set register value.
Fig. 39: Menu item “Flow rates”
8
Then return to “Operation mode” at FLOWgate
TM
.
6.2
Interface configurations of gas meter connection
6.2.1
Configuration with FLOWgate™
1
Start the FLOWgate™ software on the computer connected to the gas flow meter.
2
In the menu tree on the right side, select “PARAMETER MODIFICATION” and
“I/O CONFIGURATION”.
3
Select the desired interface.
4
Now select Protocol, Baudrate, Protocol Bits etc.
Fig. 40: Changing the interface
5
Configuration mode must be activated to make changes. Finally, the changes must be
confirmed with the “Write to device” button.
The settings at the interface only become effective when switching back to “Operation
mode”.
Deviating configurations must be set in Flow-X flow computer and in FLOWSIC600-XT.
