DIP switch 1
(row A)
DIP switch 2
(row A)
DIP switch 3
(row A)
DIP switch 4
(row A)
Function
Off
On
Off
On
Cross-muting with muting
signal 1 on system con‐
nection In4 and muting
signal 2 on extension
connection In2
Off
On
On
Off
Partial blanking based on
cross-muting
Off
On
On
On
Partial blanking based on
cross-muting with muting
signal 1 on system con‐
nection In4 and muting
signal 2 on extension
connection In2
On
Off
Off
Off
Exit monitoring
1)
2)
3)
On
Off
Off
On
Exit monitoring with mut‐
ing signal 1 on system
connection In4 and mut‐
ing signal 2 on extension
connection In2
1)
2)
3)
On
Off
On
Off
Partial blanking based on
exit monitoring
1)
2)
3)
On
Off
On
On
Partial blanking based on
exit monitoring with mut‐
ing signal 1 on system
connection In4 and mut‐
ing signal 2 on extension
connection In2
1)
2)
3)
1)
Muting hold time of 4 s.
2)
Muting end by ESPE active.
3)
Muting end delay of 200 ms.
Note on configuration
b
Check the parity after setting the DIP switch,
see "Checking the parity", page 102
.
7.7
Configuring the scanning range
Important information
NOTE
The scanning range is only configured on the receiver of a single or host system.
DANGER
Incorrect scanning width setting for dynamic protective field widths in the case of
devices with a resolution of 14 mm
Detection capability is no longer guaranteed. Persons and parts of the body to be
protected may not be detected.
b
In cases where the actual protective field width may be less than 1 m, configure
the dynamic protective field width (small range).
b
In cases where the actual protective field width is always at least 1 m, but may be
less than 2 m, configure the dynamic protective field width (medium range).
7
CONFIGURATION
98
O P E R A T I N G I N S T R U C T I O N S | deTec4
8021645/1EB0/2022-04-28 | SICK
Subject to change without notice
