Chapter
2
Online Help
Barcode Scanner CLV62x
36
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8011967/S345/2008-04-23
CLV62x
External Input 2
The second digital external input of the CDB620 connection module in connection with the
CMC600 parameter memory module or of the CDF600 connection module is configured via
the parameters of the
group.
2.2.5.5 RDT400
RDT400 protocol
The parameters of the
group are used to assign the evaluation conditions
of the code types.
2.2.5.6 Digital outputs
For certain system conditions (e.g. decoding "No Read" failed), independent switching sig-
nals which can be used for displaying the system condition can be output at the digitals out-
puts.
Output 1
The fieldbus interface is configured with the parameters of the
group.
Important
This connection is only available on the bar code scanner with a cable connector (standard
version) and for the Ethernet version via the CDB620 connection module in combination
with the parameter memory module CMC600.
Parameter
Funktion
Control
Select the type of control.
Sensitivity
Select sensitivity of sensor.
Logic
Select logic of the external input 2.
Debouncing
Enter detection time for signal at the external input 2.
If applicable, select unit.
Parameter
Function
Condition for code type 1
Select evaluation condition which should be applied for code type
1 (see
chapter 2.2.4.2 Evaluation conditions, page 23
).
Condition for code type 2
Select evaluation condition which should be applied for code type
2 (see
chapter 2.2.4.2 Evaluation conditions, page 23
).
Condition for code type 3
Select evaluation condition which should be applied for code type
3 (see
chapter 2.2.4.2 Evaluation conditions, page 23
).
Parameter
Function
Output 1
Select event that is to trigger a signal at output 1.
Logic
Select logic level of the selected output 1.
Control
Select type of control.
Duration
Enter signal duration.
If applicable, select unit.
