8017035/ZMO9/2017-06-08 • © SICK AG • Subject to change without notice.
137
Specifications
9.4
Timing Charts
This section explains the timing charts of Profiler 2 measurements
and output.
9.4.1
Measurement
The timing charts of Profiler 2 measurements are shown below.
Output switching behaviour
Tolerance judgment (upper and lower thresholds and hysteresis)
When "Out polar" is "N.O." and "On Timing" is "Out range"
t
ON
OFF
Hysteresis
Measurement not possible
Upper limit
Measured value
Lower limit
Judgment output
(control output)
Hold mode
When the hold mode is “None”
When the hold mode is “None,” hold input is ignored and the measured
result is always updated to the latest value.
ON
OFF
ON
OFF
Measured
value
Hold
Reset
