6.5
Connecting the device electrically
NOTICE
Observe the wiring instructions,
see "Wiring instructions", page 23
1.
Ensure the voltage supply is not connected.
2.
Connect the device according to the connection diagram,
6.6
Wiring the digital outputs
The device has 4 switching digital outputs.
Digital output OUT1 signals that the defined minimum distance has been undercut.
Digital output OUT2 signals that the permissible maximum number of people has been
exceeded.
Digital output OUT3 signals a device overload situation.
Digital output OUT4 is reserved and cannot be used.
The structure and wiring principle of the digital outputs are shown below.
Device
1
OUT X
2
X
Y
GND
V
out
3
4
Figure 10: Wiring of digital output (PNP version)
1
Device
2
Signal OUT X
3
Output voltage V
out
4
If an inductive load is present: Provide an arc-suppression circuit at the digital switching
output. Attach a freewheeling diode directly to the load for this purpose.
Position
Signal
TiM8xxA-21xxx (male con‐
nector M12, 12-pin): PIN
Wire colors connecting cable part no.
6054974 (5 m), 6054973 (10 m),
6054972 (20 m)
X1
OUT 1
5
Pink
X2
OUT 2
6
Yellow
X3
OUT 3
7
Black
X4
OUT 4
8
Gray
Y
GND
1
Blue
Features
Short-circuit protected and temperature protected
Not electrically isolated from supply voltage U
v
Electrical values
0 V
≤
V
out
≤
V
S
(V
S
– 1.5 V)
≤
V
out
≤
V
S
at I
out
≤
100 mA
ELECTRICAL INSTALLATION
6
8025963//2020-08-05 | SICK
O P E R A T I N G I N S T R U C T I O N S | TiM8xx DistanceGuard
25
Subject to change without notice
