siat ProWrap 16_H_FM, Руководство по эксплуатации и обслуживанию

Страница: 90 / 104

Control system
IDM 510-140-0
88
English language Operation and maintenance manual
Manual wrapping
The figure shows the points of intervention and the description shows the
procedures to be adopted.
1. Check whether the wrapping film has the same chemi-
cal-physical properties as that installed in the reel holder
carriage.
– If film characteristics appear to be different, consider wheth-
er you should adjust the film tension.
2. Rotate main disconnector G to position “I” (ON) to activate
the power supply.
– The pilot light of button F turns on.
3. Press the push-button F .
– The pilot light of button
F
turns off.
4. Correctly load the new product to be wrapped in the middle
of rotating platform.
Important
Remove the lifting device.
5. Tie the trailing end of the film to the base of the product to be
wrapped.
6. Display the MANUAL FUNCTIONS screen (3) .
See “Operator interface navigation diagram (standard)”
7. Programme all wrapping parameters.
The rotation speed must be adapted to the specifications of the load to be
wrapped (type and stability).
8. Press key B .
– The buzzer is activated to warn the personnel that machine operation is about to
start.
– The platform begins to rotate.
– The wrapping cycle starts when performing the lower reinforcing band.
9. When the reinforcing band is completed, press and hold button H to make reel
holder carriage rise.
▀
Intermediate reinforcing band
– Release button H when the reel holder carriage reaches the height of interest.
– Press and hold button H to wrap the remaining part.
▀
Upper reinforcing band with reel holder carriage descent (sin-
gle wrapping)
– Release button
H
when the reel holder carriage reaches the upper part of the
product.
– Press button
C
when the reinforcement band has been completed.
– Rotating platform stops in phase.
– Manually cut the film and cause it to adhere to the wrapped product.