siat ProWrap 16_H_FM, Руководство по эксплуатации и обслуживанию

Страница: 47 / 104

IDM 510-129-1
Pressing roller
45
English language Operation and maintenance manual
Disassembly and re-assembly of the Pressing Roller
The operation must be carried out by the maintenance technician or by per-
sonnel with suitable competences, skills and knowledge.
Make sure to fulfil the required requirements in order to work under safe con-
ditions.
– This service should be carried out with the reel holding carriage lowered and the
machine safely at a stop.
– The figure shows the points of
intervention and the description
shows the procedures to be
adopted.
1. Mark the intervention area and
prevent access to the devices
that, if activated, may cause
unexpected hazards and jeop-
ardize the safety level.
Attention
Warning
Wear the suitable personal pro-
tective equipment (gloves and
shoes) to avoid any abrasion
and/or crushing hazard.
2. Rotate main disconnector to
position
“O” (OFF) to deacti-
vate the power supply.
3. Disconnect the pneumatic sup-
ply
4. To reach high, not easily acces-
sible or otherwise hazardous
areas, implement adequate
safety measures to avoid risks.
5. Loosen the screws A and re-
move the cover B .
6. Loosen the screws C and re-
move the component D .
7. Disconnect the electric and
pneumatic connections.
8. Loosen the screws E and disas-
semble the front panel F .
9. Loosen the screws G .
10. Loosen the screws H .
11. Remove the component L .
12.
Position the component
L
in a
suitable place so that it does
not constitute any obstacle.