Si-tex SP38, Инструкция по установке и эксплуатации, Страница: 79 / 193

Sitex SP38 Installation and Operation Getting Started
Document PN 29010101 V1r0
- 79 -
As mentioned previously, WORK mode will automatically be disengaged if the vessel’s speed
rises above the Work Trip Point set by the user. While it is disengaged, all normal features
such as automatic trim and off-course alarm will be operational.
Manual WORK Mode
Even if no NMEA source of speed data is available, WORK mode can still be used, by
manually initiating it.
To do so, switch to AUTO or NAV mode, and then press the WORK button for ~1 second
until the letter ‘A´ or ‘N´ in the upper left portion of the display stops flashing, and a small
letter ‘W´ appears beside it.
Then, double-press the WORK button to bring up the Work menu. Highlight “Work Mode
State,” and then use the COURSE CHANGE knob to change the selection to “M_On”
(Manual On).
WORK mode is now engaged.
Caution! When manual WORK mode is engaged, large rudder movements may occur. If your
boat is traveling too fast, these rudder movements may affect the stability of the boat. Do not
engage manual WORK mode without first ensuring that it is safe to do so and that the boat
speed is appropriate for using WORK mode.
To disengage WORK mode, again select “Work Mode State” in the Work menu and change it
to “A_Rdy” (Automatic Ready).
To cancel WORK mode completely, press and hold the WORK button for 1 second, or switch
to STANDBY or POWER STEER mode.
You can also manually disengage WORK mode, if it has been engaged in the automatic
mode. Double-press the WORK button to bring up the Work menu. If WORK mode is
engaged, the “Work Mode State” will show “A_On” beside it. Highlight “Work Mode State,”
then use the COURSE CHANGE knob to change it to “M_Rdy” (Manual Ready).
Work Menu
The Work menu has all of the adjustable parameters that are involved with WORK mode. To
access the Work menu, double-press the WORK button.