- 41 -
E1
#$
#$
#$
#$
#$
Other Connectors
ATX Power Supply Connector (JWR1)
Locate the 20-pin male header ATX power connector (JWR1) on your
mainboard. Plug the power cable from the ATX power supply unit directly
into JWR1 ATX power supply connector.
Note 1:
The ATX power connector is directional and will not go in unless the
guides match perfectly making sure that pin#1 is properly positioned.
Note 2:
Make sure the latch of the ATX power connector clicks into place to
ensure a solid attachment.
Note 3:
Your ATX power supply must be supplied to ACPI +5V standby
power and at least 720mA compatible.
Note 4:
Make sure your power supply have enough power for higher speed
processor installed.
CPU, System, AGP Fan connectors - FAN1, FAN2, FAN3
The mainboard provides three onboard 12V cooling fan power connectors
to support CPU (FAN1), System (FAN2), and AGP (FAN3) cooling fans.
Note:
Both cable wiring and type of plug
may vary depending on the fan
maker. Keep in mind that the red wire
should always be connected to the
+12V header and the black wire to
the ground (GND) header.
E2
SENSE
GND
+12V
1
FAN2
1
FAN1
1
FAN3
1
