- 39 -
3.3 System Memory Configuration
The FB83 mainboard has two 184-pin DIMM slots that allow you to install
from 128MB up to 4GB of system memory. Each 184-pin DIMM (Dual In-line
Memory Module) Slot can accommodate 128MB, 256MB, 512MB, 1GB,
and 2GB of PC2700/PC3200 compliant 2.6V single (1 Bank) or double (2
Bank) side 64-bit wide data path DDR SDRAM modules.
Install Memory:
Install memory in any or all of the banks. The combination shown as follows.
Note: 1. Maximum installed memory is 4GB.
2. Double -side X16 DDR-SDRAM chips are not supported.
3. Registered DIMM are not supported.
4. Only unbuffered without ECC DIMM are supported.
5. Does not support X4 DDR-SDRAM.
Note : You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically.
You can check the total system memory value in the BIOS Standard
CMOS Setup menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDR SDRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
TOTAL 2 DIMM in Single or Dual Channel Mode
up to 4GB and 2GB per DIMM
Density
256 Mbit
512 Mbit
1024 Mbit
Device Width
X8
X16
X8
X16
X8
X16
Single Side
256MB 128MB
512MB
256MB
1024MB
512MB
Double Side
512MB
N/A
1024MB
N/A
2048MB
N/A
