Shred Emulsifier SE1-PRO, Руководство пользователя

Страница: 7 / 16

7
Assembling the Shred Emulsifier
TM
(continued)
3. Insert the E-Z Lock Cap into the Lid (aligning the
Cap’s tabs with the Lid’s slots) and turn clockwise
to the lock symbol.
NOTE:
While the power is on and as air pressure inside
the Pitcher increases, steam will automatically
escape from the vents on the side of the Cap.
4. Place Lid on Pitcher and push down firmly until Lid
Tabs snap into position over the Lip of the Pitcher.
5. Make sure the unit is assembled properly before
connecting the power cord to the electrical outlet.
Once the Shred Emulsifier
TM
is plugged in,
the Power Button will light up blue. But the LED
Display will not be lit up. This means the Shred
Emulsifier
TM
is not ON but there is POWER.
6. Once you push the Power Button, the LED Display
will illuminate. Before selecting a Processing or
Pre-Set Button, hold the top of the assembled unit
to prevent tipping on start-up.
7. After pushing the STOP Button or when a Pre-
Set Function has finished, wait until the Blades
completely stop spinning and unit is unplugged
before removing the Cap, Lid, or Pitcher.
NOTE: Unit will not turn on until Weighted Safety
Switch is fully engaged. The Safety Switch is located
in the Base where it connects to the Pitcher. Should
the unit overheat during operation the motor will
automatically shut off. To restore power allow the
machine to cool down for 35 minutes.
Cap Tab
Lid Tab
3
4