SHOWTEC XS-2 Dual Beam, Руководство пользователя

Страница: 9 / 32

8
Ordercode: 40173
XS-2 Dual Beam
Control Modes
There are 4 modes:
• Stand-alone (built-in programs)
• Sound-controlled mode
• Master/Slave mode
• DMX512 (10, 17 or 20 channels)
One XS-2 Dual Beam (Built-in Programs)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the XS-2 Dual Beam is not connected with a DMX-cable, it functions as a stand-alone device.
Please, see page 13 for more information about the built-in programs (2.2 Auto).
One XS-2 Dual Beam (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the XS-2 Dual Beam will react to the
music beats. Please, see page 13 for more information about the sound control options (2.3 Sound).
Multiple Dual Beams (Master/Slave control)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Dual Beams.
04) Plug the end of the electric mains power cord into a proper electric power supply socket.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in (Fig.03). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 13 (Auto or Sound). This means
on the master device you can set your desired operation Mode and all slave devices will react the
same as the master device.
Multiple XS-2 Dual Beams (Master/Slave control)
Fig. 03