SHOWTEC XS-2 Dual Beam, Руководство пользователя

Страница: 8 / 32

7
Ordercode: 40173
XS-2 Dual Beam
Backside
Fig. 02
03)
Adjustment screw
04) 3-pin DMX signal connector IN
05) 3-pin DMX signal connector OUT
06) IEC Power connector 100-240V (OUT)
07) IEC Power connector 100-240V (IN)
08) Fuse F3AL/250V
09) Safety eye
10) T-bar, attach the Dual Beam to a truss, using the included M10 screws and the mounting bracket.
Installation
Remove all packing materials from the XS-2 Dual Beam. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.