SHOWTEC XS-2 Dual Beam, Руководство пользователя

Страница: 12 / 32

11
Ordercode: 40173
XS-2 Dual Beam
Control Panel
Fig. 05
A. LCD Display D. Down button
B. Mode button E. Enter button
C. Up button
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. When you select the DMX address and save it,
the controller will display the saved DMX address the next time.
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the XS-2 Dual Beam will respond to the controller.
Please note, when you use the controller and set the XS-2 to maximum settings, the unit has
20 channels.
When using multiple Dual Beams, make sure you set the DMX addresses right.
Therefore, the DMX address of the first XS-2 should be
1(001) ; the DMX address of the second XS-2
should be 1+20=21 (021 ); the DMX address of the third XS-2 should be 21+20=41 (041) , etc.
Please, be sure that you do not have any overlapping channels in order to control each fixture correctly.
If two or more fixtures are addressed similarly, they will work similarly.
Controlling:
After having addressed all the fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the XS-2 Dual Beam will automatically detect whether DMX 512 data is received
or not.
If there is no data received at the DMX-input, the LED
on the control panel will not flash.
If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the XS-2.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.