SHOWTEC Phantom 70 Beam RGBW, Руководство пользователя

Страница: 12 / 36

11
Ordercode: 40051
Phantom 70 Beam RGBW
Control Modes
There are 5 modes:
• Built-in programs (Master Mode)
• Manual
• Sound-controlled
• Master/Slave Mode
• DMX-512 (8CH, 12CH, 16CH)
One Phantom 70 Beam RGBW (Built-in Programs and Manual)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Phantom 70 Beam RGBW is not connected with a DMX-cable, it functions as a stand-alone
device. Please see page 17 and 18 for more information.
One Phantom 70 Beam RGBW (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Phantom 70 Beam will react to the
beat of the music. Please see page 18 for more information about the sound-control options.
Multiple Phantom Beams (Master/Slave Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Phantom Beams.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in (Fig.04). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 17-18. This means that you can
set your desired operation mode on the master device and all slave devices will react the same as
the master device.
Multiple Phantom Beams (Master/Slave Set Up)
Fig. 04