SHOWTEC Performer Profile IP Q4, Руководство пользователя

Страница: 15 / 40

14
Order code: 33111
Performer Profile IP Q4
The Performer Profile IP Q4 can be operated with controller or without controller in stand-alone mode.
Control Panel
A) OLED display
B) UP button
C) DOWN button
D) ENTER button
E) MENU button
Fig. 12
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Performer will respond to the controller.
Please note, when you use the controller, the unit has 17 channels.
When using multiple Performers, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Performer should be 1(001); the DMX address of the second
Performer should be 1+17=18 (018); the DMX address of the third Performer should be 18+17=32 (032),
etc.
Please, be sure that you do not have any overlapping channels in order to control each Performer
correctly. If two or more Performers are addressed similarly, they will work similarly.
Controlling:
After having addressed all Performer fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Performer will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX input, the “LED“ on the control panel will not flash.
If not, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Performer.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 25 seconds
When no button is pressed for 25 seconds, the display will turn off.
To light up the display, you have to press one of the buttons: MENU, ENTER, UP or DOWN.
Once you have pressed the buttons, the display will light up.