SHOWTEC Performer 60 LED, Руководство пользователя

Страница: 16 / 24

15
Ordercode: 33100
Performer 60 LED
1. Show Mode
With this menu you can activate the built-in show.
01) Press the MODE button until the display shows .
02) Press the SETUP button several times to toggle between strobe frequency and program speed
settings.
03) Press the UP/DOWN buttons to change the values.
Program speed, from slow to fast
Strobe frequency, from low to high frequency
2. Slave Mode
With this menu you can set the device as a slave.
01) Press the MODE button until the display shows .
02) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master. If the device has been set to slave, it will react the same as its master
device.
3. DMX Addressing / DMX Configuration
With this menu you can set the DMX address and control the DMX configuration.
01) Press the MODE button until the display shows .
02) Press the SETUP button to open the menu. You can choose 512 different DMX addresses.
03) Press the UP/DOWN buttons to select the required address from .
Once you have set the desired DMX address, you can also set the DMX mode.
04) Press the SETUP button again to proceed to the channel mode settings.
05) Press the UP/DOWN buttons to choose one of the 2 channel modes. The available options are
.
4. Sound-controlled Mode
01) Press the MODE button until the display shows .
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to set the sound sensitivity. The adjustment range is between
, from OFF to high sound sensitivity.
5. Dimmer Mode
With this menu you can set the intensity of the LED.
01) Press the MODE button until the display shows .
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to set the intensity of the LED between .