SHOWTEC Mini Q-Strobe, Руководство пользователя

Страница: 8 / 12

7
Ordercode: 40225
Mini Q-Strobe
Backside
Fig. 02
04)
Strobe frequency control
05) Power switch ON/OFF
06) 220-240V AC, CEE 7/16 Europlug power cable IN (0,75 m)
Installation
Remove all packing materials from the Mini Q-Strobe. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
01)
Make sure that the mains power supply matches the fixture’s requirements.
02) Plug the power cable (06) into an appropriate power supply.
03) Flick the power switch (05) to ON position.
04) Turn the control (04) to the left/right to decrease/increase the strobe frequency. The adjustment
range is between 1-15 flashes/sec.
05) In order to switch the device off, flick the power switch (05) to OFF position and unplug the power
cable (06) .