SHOWTEC LED PAR 64 AIRCRAFT, Руководство пользователя

Страница: 10 / 24

9
Ordercode: 30743
LED Par 64 Aircraft
Installation
Remove all packing materials from the LED Par 64 Aircraft. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 3 modes: ● Stand-alone (built-in programs)
● Manual Dimmer Operation
● DMX512 (1, 2 or 3 Channels)
One Aircraft (Built-in Programs)
01) Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Aircraft is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 14 for more information about the built-in programs.
One Aircraft (Manual Dimmer Operation)
01) Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Aircraft is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 14 for more information about the manual dimmer control.