SHOWTEC Helix S5000 Q4, Руководство пользователя

Страница: 15 / 44

14
Ordercode: 43725
Helix S5000 Q4
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 6 modes: ● Auto
● Built-in Programs
● Manual
● Master/Slave
● DMX512 (4CH, 6CH, 8CH, 20CH, 24CH)
● Wireless DMX control
One Helix (Auto, Built-in Programs)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Helix is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see pages 25-27 for more information about Auto and Built-in programs.
One Helix (Manual Mode)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Helix is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 25 for more information about Manual mode.
Multiple Helixes (Master / Slave Control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 5-pin XLR cable to connect the Helix.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
04) N/C
05) N/C
05) Link the units as shown in fig. 07. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. You can use the
same functions on the master device as described on pages 23-27. This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Helixes (Master/Slave Set Up)
Fig. 07