SHOWTEC GALACTIC BEAM G40 V1, Руководство пользователя

Страница: 13 / 28

12
Ordercode: 51315
Galactic Beam G40
Control Modes
There are 4 modes: Auto run (visual effects)
Sound-controlled
Master/Slave
DMX512
One Galactic Auto run (visual effects)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 17 for more information about the Auto run visual effects.
One Galactic Sound-controlled
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 17+18 for more information about the about the sound-control options.
Multiple Galactics (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-p XLR cable to connect the Galactic.
The pins: 1. Earth
2. Signal (-)
3. Signal (+)
05) Link the units as shown in (Fig. 03), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 17+18 (Autorun or Music
control). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
Multiple Galactics ( Master/Slave control)
Fig. 03