SHOWTEC DRAGON 500, Руководство пользователя, Страница: 8 / 12

7
Ordercode: 61100
Dragon 500
Backside
Fig. 02
09)
Remote control cable (3,3 m)
10) ON/OFF
11) IEC Powercon Fuse 3AL/250V
12) Fog liquid level indicator
Installation
Remove all packing materials from the Dragon 500 fogger. Check that all foam and plastic padding is
removed, especially in the snow output sleeve area.
Fill with Fog Liquid (ordercode 60603) or other high-quality water-based fog fluid. Any other types of fluid
can damage the unit. Be careful not to exceed the maximum fluid level.
DO NOT OVERFILL .
When filled, place cap back on liquid tank.
Firmly attach the remote control cable to the proper input on the rear of the machine
The unit can also be operated at floor level or sitting on any regular surface as well.
If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at
anyone’s face. Therefore, do not point the nozzle in a direction that will aim directly at a person.
Whatever installation method you choose, the maximum inclination angle of the device should not
exceed 15º.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Note: Always monitor tank fluid level as you are fogging!
Note: Be careful not to exceed the maximum fluid level. DO NOT OVERFILL!
Note: Running a fogger with no fog liquid can permanently damage the unit!
Procedure
:
01) Plug power cord into a grounded electrical outlet.
02) To emit fog, press the button on the remote and hold for the desired length of time.
03) The remote unit’s LED will cycle on and off as the machine re-heats to the proper operating
temperature.