SHOWTEC 44560, Руководство пользователя

Страница: 22 / 44

21
Pixel Panel 1024
Product code: 44560
Art-Net Settings
To run your device using Art-Net protocol:
Configure the network address of your computer/lighting controller in the correct range (IP 2.x.x.x,
10.x.x.x or 192.168.x.x and Subnet 255.0.0.0). To change the IP address of the device, refer to 6.6.2.1.
Set Manual/DHCP on page 29 and 6.6.2.2. Set IP Address on page 29. To change the Subnet mask,
refer to 6.6.2.3. Set Net Mask on page 29. Make sure that all devices in the network have unique IP
addresses.
Note: Art-Net 4 supports both DHCP and static addressing.
Select Art-Net Protocol in the Set Net Protocol menu. See 6.6.3.2. Art-Net on page 31 or 6.6.3.3. Kling-
Net on page 31.
Set the universe. See 5.4.6. Universe Numbering on page 22.
Kling-Net Settings
To run your device using Kling-Net protocol:
Install any Kling-Net-based software on your computer.
Make sure that your computer has a fixed IP address.
Select KlingNet IP in the Set IP Mode menu. See 6.6.2.1. Set Manual/DHCP on page 29. The Kling-Net-
based software will automatically configure the IP address of the device.
Select KlingNet Protocol in the Set Net Protocol menu. See 6.6.3.2. Art-Net on page 31 or 6.6.3.3.
Kling-Net on page 31.
Map the device following the instructions of the Kling-Net-based software.