FCC/IC
Federal Communications Commission (FCC) Statement
FCC Caution: Any changes or modi
fi
cations not expressly approved by the party responsible for
compliance could void the user
’
s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may caus harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.Increase the separation between the equipment and
receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.Consult the dealer or an experienced radio/TV technician for help.This equipment
should be installed and operated with minimum distance 20cm between the radiator and your body.
IC Caution:Door window sensor
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired
operation of the device.
DECLARATION DE CONFORMITE D'INDUSTRIE CANADA
Ce p
é
riph
é
rique a
é
t
é
test
é
et reconnu conforme aux limites sp
é
ci
fié
es dans RSS-210.
Son utilisation est soumise aux deux conditions suivantes :
(1) il ne doit pas provoquer d'interf
é
rences g
ê
nantes et
(2) il doit tol
é
rer les interf
é
rences re.ues, notamment cellessusceptibles d'en perturber le fonctionnement.
Show Home Products warrants this product to be free from manufacturing defects for
ZW112 Motion Sensor
Motion Sensor
WARRANTY
Show Home Products warrants this product to be free from manufacturing defects for
a period of two years from the original date of consumer purchase. This warranty is limited
to the repair or replacement of this product only and does not extend to consequential or
incidental damage to other products that may be used with this product.
This warranty is in lieu of all other warranties, expressed or implied. Some states do not
allow limitations on how long an implied warranty lasts or permit the exclusion or limitation
RISK OF FIRE
of incidental or consequential damage, so the above limitations may not apply to you.
RISK OF ELECTRICAL SHOCK
RISK OF BURNS
This warranty gives you speci
fi
c rights, and you may also have other rights which vary from CONTROLLING APPLIANCES:
state to state. if the unit should prove defective within the warranty period.
EXERCISE EXTREME CAUTION WHEN USING Z-WAVE
DEVICES TO CONTROL APPLIANCES. OPERATION
OF THE Z-WAVE DEVICE MAY BE IN A DIFFERENT
ROOM THAN THE CONTROLLED APPLIANCE, ALSO AN
UNINTENTIONAL ACTIVATION MAY OCCUR IF THE WRONG
BUTTON ON THE REMOTE IS PRESSED. Z-WAVE DEVICES
Model:ZW112
MAY AUTOMATICALLY BE POWERED ON DUE TO TIMED
Power supply: battery CR123A, 3V.
EVENT PROGRAMMING. DEPENDING UPON THE APPLI-
Signal (Frequency): 908.42 MHz.
ANCE, THESE UNATTENDED OR UNINTENTIONAL OP-
Operating Range: Up to 100 feet line of sight
ERATIONS COULD POSSIBLY RESULT IN A HAZARDOUS
Operating Temp.: -15
°
C~60
°
C (5
°
F ~140
°
F)
CONDITION. FOR THESE REASONS, WE RECOMMEND
Wireless Controller and the closest Z-Wave
DO NOT RETURN THIS PRODUCT TO THE STORE
receiver module.
THE FOLLOWING:
Speci
fi
cations subject to change without notice
DO NOT USE Z-WAVE DEVICES TO CONTROL ELECTRIC
due to continuing product improvement
HEATERS OR ANY OTHER APPLIANCES WHICH MAY PRESENT
Website www.ishowlights.com
A HAZARDOUS CONDITION DUE TO UNATTENDED OR
UNINTENTIONAL OR AUTOMATIC POWER ON CONTROL.
1.Do not attempt to disassemble the Motion Sensor,unless described in the user
’
s manual. There are no user serviceable parts.
2.Handle with Care
–
Avoid striking or shaking.Improper use or storage could damage the Motion Sensor. Modifying or tampering
the device or its internal components can cause a malfunction and void the Motion Sensor
’
s warranty.
3.If you feel the Motion Sensor or any part of the Choice Alert system is not operating correctly or as described, please contact us.
SPECIFICATIONS
WARNING
Important safeguards
