Showgear VIBE FX Polar Beat, Руководство пользователя

Страница: 12 / 16

11
Ordercode: 950300
VIBE FX Polar Beat
Fig. 03
06)
Effect switch ON/OFF
While in Auto, Sound-controlled or Bluetooth mode, press the button to switch the effects on/off.
Each press of the button corresponds with a different setting. There are 3 settings:
●
Laser ON, LED OFF
● Laser OFF, LED OFF
● Laser ON, LED ON
07)
Control mode/power switch
Move the switch to the left, to activate Sound-controlled mode.
Move the switch to the right, to activate Auto mode.
Move the switch to the center, to switch the Polar Beat off.
08)
Bracket
Installation
Remove all packing materials from the VIBE FX Polar Beat. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Exclusion of Liability
Be aware that in some countries, there are additional regulations, regarding the use of laser devices.
Therefore, we strongly advise you to verify your national laws with your authorities: We do not take any
responsibility for eventual discrepancies, changes or adaptions regarding lawful use of laser devices.