17
Door Rotation/Component Relocation
The O
2 Door can be flipped or rotated so that the door will swing in the opposite direction.
The components/accessories have to be removed, relocated and reattached.
Depending upon the configuration of the O2
Door, components and procedures may vary.
FIGURE 3.15 - Rotate Door
RIGHT-HAND
LATCH (PULL)
LEFT-HAND
LATCH (PULL)
ROTATE
DOOR
180°
FIGURE 3.16 - Rotated Door
REMOVE
RELOCATE
REATTACH
HINGE
BUSHING
REMOVE
ROTATE
REATTACH
LATCH
POST
REMOVE
ROTATE
REATTACH
STEP 1:
Rotate the door 180
°
about the face so that the hinge bushings are located on the
right hand side of the door. See FIGURE 3.15 & 3.16
Remove, rotate and reattach the Thermometer/
Hygrometer to reorient the meter to read correctly.
Ensure the meter is reinstalled on the backside (cage-
side) of the door.
Do NOT attempt to remove the meter by sliding it
out of the bracket while still attached to the door,
may scratch the door surface.
STEP 2:
Remove the two screws, washers and
acorn nuts to detach the bracket and meter.
Reinstall the meter to read upright. See
FIGURE 3.17
The O2 door Humidifier holder and O2
analyzer/door plug swap positions.
STEP 3:
Remove the O
2
analyzer/door plug:
A:
O
2
analyzer - Remove the O
2
Analyzer by turning the cover (backside)
counterclockwise, slide the O
2
Analyzer out of the hole. Set aside for the moment.
See FIGURE 3.18
B:
Door Plug - Remove the door plug assembly with a Phillips head screwdriver, turn
the screw counterclockwise to loosen, remove. Set aside for the moment. See
FIGURE 3.19
FIGURE 3.18 - O2 Analyzer Removal
O2 ANALYZER
FIGURE 3.19 - Door Plug Removal
REMOVE
PLUG
ASSEMBLY
O2 ANALYZER
COVER
FIGURE 3.17 - Thermometer/Hygrometer
SECTION THREE
