-23-
Model W1850 (For Machines Mfd. Since 06/17)
O
PE
R
ATIO
NS
Disc.Sanding
To.perform.sanding.operations.with.the.sanding.disc,.
do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2..
Adjust angles of disc sanding table and miter gauge
for operation.
3.
Connect sander to power, turn it
ON
, and allow it to
reach full speed.
4..
Place workpiece on table and firmly against miter
gauge.
.
Note:.
To prevent burning workpiece and overloading
sanding disc, move workpiece slowly back and forth
from left side of sanding disc to center of sanding
disc.
5.
Slowly, and with light pressure, move workpiece
into left side of sanding disc. See
Figures.25–27
for
examples of disc sanding.
Always. keep. workpiece. on. left. side.
of. wheel. that. rotates. down. toward.
table. as. shown. below.. This. will. keep.
workpiece. from. flying. out. of. your.
hands.due.to.kickback.
Figure.25.
Example of 90° disc sanding.
Figure.26.
Example of miter sanding.
Figure.27.
Example of angle sanding.
Use Only
Left Half
of Rotating
Sanding Disc
Kickback
Hazard
Area:
DO NOT
USE
Kickback
Hazard
Area:
DO NOT
USE
Kickback
Hazard
Area:
DO NOT
USE
Use Only
Left Half
of Rotating
Sanding Disc
Use Only
Left Half
of Rotating
Sanding Disc