-18-
Model W1850 (For Machines Mfd. Since 06/17)
SE
TU
P
11.
Rotate disc until set screw is visible through hole
on back of V-belt safety cover and use 2.5mm
hex wrench to secure disc to motor arbor (see
Figure.14
).
Figure.16.
Using thin cardboard
(
1
⁄
16
" thick) for clearance gauge.
12.
Install disc dust cover, as shown in
Figure.15,
with
(3) M4-.7 x 8 Phillips head screws and 4mm flat
washers.
13.
Gently lay sander on flat surface, as shown in
Figure.
16
, and place thin piece of cardboard approximately
1
⁄
16
" thick over sanding disc. Cardboard acts as
spacer when installing disc table.
14.
Keeping cardboard in place, align half-arc key of disc
table with indented keyway on disc guard (see inset
of
Figure.17
).
15. Secure table with table lock handle, then remove
cardboard.
Figure.15.
Disc dust cover installed.
Figure.17.
Sanding disc table installed.
Table Lock Handle
Figure.14.
Securing sanding disc set screw.
Set Screw
Access Hole
Key
Keyway
Disc Dust
Cover
