-16-
Model W1850 (For Machines Mfd. Since 06/17)
SE
TU
P
Assembly
Before beginning the assembly process, refer to
Items
Needed for Setup and gather the items you will need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory
(if applicable). Be sure to complete all steps in this
procedure prior to performing the
Test.Run
.
To.assemble.machine,.do.these.steps:
1.
Loosen (4) motor mount hex bolts (see
Figure.7
) to
adjust motor position in following steps.
2.
With assistance from another person, position belt
housing assembly on left side of base, taking care
not to pinch power cords between assembly and
base.
3.
Place V-belt around both pulleys, and secure belt
housing assembly with (2) M10-1.5 x 20 cap screws,
10mm lock washers, and 10mm flat washers (see
Figures.8–9
). DO NOT fully tighten fasteners yet.
Figure.8.
Cap screws for belt housing.
Items.Needed.
Qty
Another Person ..................................................1
Open-End Wrench 13mm.......................................1
Hex Wrench 8mm ..............................................1
Phillips Screwdriver #2 .........................................1
Hex Wrench 2.5mm .............................................1
Figure.9.
Belt housing assembly installed.
Base
Belt Housing
Assembly
4.
Center motor arbor in cutout of cast-iron disc guard
(see
Figure.10
), then re-tighten (4) motor mount
hex bolts from
Step 1.
Figure.10.
Motor arbor centered.
Arbor
Arbor
Cutout
Motor
Figure.7.
Motor mounting hex bolts (2 of
4, viewed from top).
Motor Mounting
Hex Bolts (2 of 4)