Shop fox W1838, Руководство пользователя

Страница: 17 / 37

-14-
Model W1838 (For Machines Mfd. Since 6/16)
SE
TU
P
Recommended.CFM.at.Dust.Port.................. 150.CFM
Dust.Collection
The dust ports are located behind both the sanding belt
and the sanding disc. Each opening is 1
1
⁄
2
" in diameter
and can be connected to a utility vacuum or a dust
collector.
Tools.Needed. Qty
Dust Collection System ........................................1
Dust Hose 1
1
⁄
2
" ..................................................1
Hose Clamps 4" ..................................................2
To.connect.a.dust.collection.hose,.do.these.steps:
1. Fit 2
1
⁄
2
" dust hose over dust port, as shown in Figure
9
, and secure in place with hose clamp.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection “how-to” book.
This. machine. creates. substantial. amounts. of. dust.
during.operation..Breathing.airborne.dust.on.a.regu-
lar.basis.can.result.in.permanent.respiratory.illness..
Reduce.your.risk.by.wearing.a.respirator.and.captur-
ing.the.dust.with.a.dust.collection.system.
Figure.9.
Dust port with dust collection
hose installed.
Dust Port