Shop fox W1838, Руководство пользователя

Страница: 16 / 37

-13-
Model W1838 (For Machines Mfd. Since 6/16)
SE
TU
P
Bench.Mounting
Number.of.Mounting.Holes................................... 4
Diameter.of.Mounting.Hardware.Needed...............
1
⁄
2
"
Machine Base
Workbench
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Figure.5. Typical "Through Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Figure.6.
Typical "Direct Mount" setup.
The base of this machine has mounting holes that allow it
to be fastened to a workbench or other mounting surface
to prevent it from moving during operation and causing
accidental injury or damage.
The strongest mounting option is a “Through Mount” (see
example) where holes are drilled all the way through the
workbench—and hex bolts, washers, and hex nuts are
used to secure the machine in place.
Another option is a “Direct Mount” (see example) where
the machine is secured directly to the workbench with lag
screws and washers.
Figure.7. Installing disc table.
Flat Washer
(1 of 2)
Lock Knob
(1 of 2)
Assembly
To assemble machine, do these steps:
1. Attach disc sanding table with (2) M6-1 x 18 lock
knobs and (2) 6mm flat washers (see
Figure.7
).
2.
Set table to desired angle and tighten lock knobs.
3.
Attach backstop with (1) M5-.8 x 10 lock knob, (1)
5mm washer, and (1) M5-.8 hex nut, as shown in
Figure.8 .
4. Use a square to position backstop perpendicular to
sanding belt, as shown in Figure. 8 , with approxi-
mately
1
⁄
8
" between backstop and belt. Tighten angle
knob to secure setting.
The Model W1838 ships with the sanding belt and sanding
disc pre-installed.
Figure.8. Squaring the backstop.
Angle Knob
Flat Washer
Hex Nut
Back
Stop