Shop fox SHOP FOX W1717, Инструкция по эксплуатации

Страница: 22 / 30

-20-
Figure 23. Contour sanding operation.
Bevel sanding operations can be done when the
belt is tilted to a specific angle.
To start a bevel sanding operations, do these
steps:
1. UNPLUG THE SANDER!
2. Loosen the belt tilting lock knob and rotate
the sanding belt to the desired angle, then
tighten the lock knob.
3. Plug the sander into the power source.
4. Start the sander.
5. Firmly hold the workpiece against the table
and feed it into the sander as shown in
FIgure 23 .
Figure 20.
Table at 180˚.
Flat sanding operations can be performed with
the sanding belt tilted to 180˚.
To start flat sanding operations, do these
steps:
1. UNPLUG THE SANDER!
2. Loosen the belt tilting lock knob shown in
and rotate the sanding belt to the 180˚
mark on the scale (
FIgure 20 ).
3. Tighten the lock knob.
4. Make sure the work stop is installed to pre-
vent the workpiece from running off the
sanding belt.
5. Plug the sander into the power supply.
6. Start the sander.
7. Hold the workpiece firmly in both hands as
shown in
Figure 21 .
Figure 21.
Flat sanding operation.
Bevel Sanding
Flat Sanding