Shinybow USA SB-5654, Инструкция по эксплуатации, Страница: 8 / 12

10
POWER POWER
1x4 HDMI DISTRIBUTION 1x4 HDMI DISTRIBUTION
ON ON OFF OFF
0F
PAGE 8
SB-5654 INSTRUCTION & OPERATION MANUAL
Before making any connections to the SB-5654. Observe the following:
> Ensure the mains voltage supply matches the label on the supplied plug-
Pack (+/- 10%)
> Ensure that the power switch is OFF
> Ensure that all system grounds (earth) are connected to a common point.
> Avoid powering equipment within a system from multiple power sources
that may be separated by large distances
REMOTE CONTROL
REMOTE CONTROL
> Connect all audio video sources and destination equipment
> power up all source and destination audio-visual sources
> For each destination output select the appropriate input source by using
> Upon power up the distributor will return to its last used setting before
The front panel supplied IR remote control.
Powered down.
SWITCH POWER ON or OFF 1
Controller with a separate power ON and OFF
2
2
1
CONNECTING THE HARDWARE
Please study the panel drawings below and become familiar with the signal input-output, Power requirements plus any controls
present.
Before using the switcher, please take the time to make certain that the device you wish to connect to its inputs is functioning
properly in all respects. Verify that the video and audio signals are present and are being displayed properly on a suitable device.
If all is well connect the appropriate cables between the output of the device you wish to distribute to output(s) of the switcher to
the carious devices you wish to feed a signal to. Lastly, connect the AC to DC adaptor, connect the DC connector to the switcher
first and then plug the adaptor into a functional AC outlet.