Shinybow USA SB-3888, Инструкция по эксплуатации, Страница: 21 / 40

19
FUNCTION KEY - MENU [RESET]
26. FUNCTION KEY: MENU [RESET]
FOR RETURN TO FACTORY DEFAULT.
The LCM display will show the SYSTEM RESET status. The system will return to factory default.
To setup the switcher for the SYSTEM RESET command, perform the following steps:
1. Press the DESTINATION 1 OR 2 function button to select OUTPUT #1 or OUTPUT #2 (the button will illuminate). Press the ENTER
button to confirm the new configuration or press EXIT to cancel the operation.
2. Press the LEFT or RIGHT circular button to select SYSTEM RESET ON or OFF function (the button will illuminate).
RESET MODE:
1 - System Reset - ON
2 - System Reset - OFF
3. Press ENTER . The new configuration will be stored or press EXIT to cancel the operation.
The new configuration will be stored and the LCM will return to the default screen showing the selected Matrix/PiP/PoP status.
Operation completes.
FACTORY DEFAULT TABLE:
1. The Resolution Output returns to 1080p-60Hz (2CH). 6. The TV Video system Output returns to NTSC 3.58 MHz.
2. The SW mode returns to Source #1. 7. The IP, RS-232 Brad Rate returns to 9600
3. The PiP mode returns to Source # OUT-1 A/B (1,2) and
OUT-2 C/D (3,4).
8. The IP Channel returns to CH-001
4. The PoP mode returns to source # OUT-1 A/B (1,2) and
OUT-2 C/D (3,4).
9. The Coax Channel returns to CH-001
5. The EDID LEARNING mode shows Enabled. 10. The Memory mode returns to empty.