SPECIFICATIONS
EB910 / RT
48
X7501200800
© 09/20 ECHO Incorporated
1.
Store unit in a dry, dust free place, out of the reach of children.
2.
Place the stop switch or lever in the “OFF” position.
3.
Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4.
Perform all periodic lubrication and services that are required.
5.
Tighten all the screws and nuts.
6.
Drain fuel tank completely. Press purge bulb 6 -7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7.
Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
8.
Pull the recoil starter handle 2-3 times to distribute the oil inside the
engine.
9.
Observe the piston location through the spark plug hole. Pull the recoil
handle slowly until the piston reaches the top of its travel and leave it
there.
10. Install the spark plug. Connect the spark plug lead to the spark plug.
11. Remove blower pipe assembly from unit.
SPECIFICATIONS
MODEL
EB910
EB910 RT
Length (with pipes)
1564 mm (61.6 in. )
Width (with pipes)
630 mm (24.8 in.)
603 mm (23.7 in.)
Height (with pipes)
544 mm (21.4 in.)
Weight (full tank) (w th pipes) 13.2 kg (29.1 lb.)
13.1 kg (28.8 lb.)
Engine Type
Air cooled, two-stroke, single cylinder gasoline
engine
Bore
53 mm (2.1 in.)
Stroke
36.2 mm (1.4 in.)
Displacement
79.9 cc (4.9 cu
3
)
Exhaust
Spark arrestor muffler or spark arrestor muffler with
catalyst
Carburetor
Diaphragm with purge pump
Ignition System
Flywheel magneto, capacitor discharge ignition type
Spark Plug
NGK CMR7H – Gap 0.65 mm (0.026 in.)
Fuel
Mixed (Gasoline and Two-stroke Oil)