9
Installing a Blade
1. Make sure the switch is off and the
engine is stopped.
2. Wear gloves to protect your hands.
3. Turn the unit over so the saw holder
flange extending from the gear case is
facing up.
4. Using the small end of the plug wrench,
loosen the bolt (turn clockwise) and
remove the bolt, bolt guard, and
holder B.
WARNING!
Make sure the direction of the
arrow indicated on the blade corresponds
with the arrow indicated on the cutting
attachment shield.
7. Put holder B and bolt guard back and
at this time only finger tighten the bolt.
Make sure holder B is flat against the
blade. The recess in holder B must
face the blade and completely cover the
safety clip.
WARNING!
Never operate this machine
without the safety clip in
place.
6. Fit the blade over the safety clip onto
holder A. Then, slide the safety clip back
to its original position.
WARNING!
The blade must fit flat against
holder A. The blade’s mounting
hole must be centered over the raised
boss of holder A.
SHAFT BOLT
BOLT GUARD
HOLDER B
SAFETY CLIPS
HOLDER A
GEAR SHAFT
5. Slide the safety clip as shown in the
illustration.
Slide the saw blade in place
Center the safety clip(s)
Install Holder B
8. Rotate holder A until the hole in its
skirt aligns with the hole in the gear
case. Insert the hex wrench through
both holes (to prevent the shaft from
turning).
9. Holding the hex wrench and blade
with one hand, tighten the bolt (turn
counterclockwise) securely using the
hex socket end of the plug wrench.
The brushcutter should be fully assembled.
10. Remove the hex wrench.
WARNING!
Before operating, make sure
the blade is securely mounted. Turn the
blade with your hand slightly and make
sure the blade turns smoothly without
wobbling.
